Call ENNO: +65 62605464, +65 62605465

  • Press-wood Pallets
  • Eagon Press-wood Pallets
  • Plastic Pallets
  • Plywood Panels
  • Galvanized Steel Pallets
  • Steel Nestainers

PWP Quality Test

The type of test : Static test according to the test method of KS A 1044

    1. AIR BAG PRESS LOAD TEST
      1. Purpose: Think of actual state on the spot
        1. Put air-bag of middle pressure on the pallet
        2. Pressure of air-bag should be enough to measure the Maximum Static load.
      2. Standard : Over 3,000 Kg.f
      Air Bag (before test) Air Bag (after test)
    2. FORK LIFTING BENDING TEST(Dynamic Load test)
      1. Purpose : To measure the static of pallet using Fork lifting.
      2. Method of test : Same as the method of air-bag test, but it should be tested by inserting Fork on the bottom of upper pallet.
      3. Standard : Over 2,500 kg.f
      Air Bag (before test) Air Bag (after test)
    3. PALLET LEG PRESS TEST
      1. Purpose : Think of the weight is concentrated on a position
      2. Method : Test to concentrate weight on a position of pallet with cutting a leg of the pallet
      3. Suppose the results of upper & https://www.viagrapascherfr.com/achat-sildenafil-mylan/ lower of legs are same.
      4. Standard : Over 2,000 kg.f
      Leg press test (upper leg-before) Leg press test (upper leg-after)
      Leg press test (lower leg-before) Leg press test (lower leg-after)
    4. HOLDING STRENGTH TEST OF SCREWS
      1. Purpose : To test volume power between Runner and pallet
      2. Method : Put buttress on the center of Runner and weight with air-bag until falling out screws
      Holding strength of screws(before) Holding strength of screws(after)